PowerSite 1.0 Datawindow DTC & Power++ 2.0 Datawindow Control

Whenever I install Power++ 2.0, I get the appropriate datawindow
control.  As soon as I install PowerSite 1.0, I lose the DataWindow
control and I can't register the new PowerSite control on top of it
properly (or I don't know how).  If I try installing PowerSite first and
then Power++ I lose the Datawindow DTC control.  Since these controls
are obviously different, why is one overwriting the other's
configuration, and how can I correct this situation?

Any help would be much appreciated

0 Brendan 3/28/1998 10:39:53 PM

Hello Brendan,

This issue has been previously reported as issue 498849.  Until it is
resolved the workaround is to run regsvr32 psdwe060.ocx  before using
PowerSite and regsvr32 psdwe.oxc before using Power++.

Regards,

Dan van Leeuwen
PowerSite Technical Support Group

On Sat, 28 Mar 1998 17:39:53 -0500, Brendan Newman 
wrote:

>Whenever I install Power++ 2.0, I get the appropriate datawindow
>control.  As soon as I install PowerSite 1.0, I lose the DataWindow
>control and I can't register the new PowerSite control on top of it
>properly (or I don't know how).  If I try installing PowerSite first and
>then Power++ I lose the Datawindow DTC control.  Since these controls
>are obviously different, why is one overwriting the other's
>configuration, and how can I correct this situation?
>
>Any help would be much appreciated
>

0 danielva 3/29/1998 7:53:05 PM